Home :: Accessories :: Finderscopes & Brackets :: Finderscope Brackets :: 80mm Finderscope Brackets

80mm Finderscope Brackets

Products

Sort by: Product Price Default
  •  per page
Stellarvue 80 mm Finder Rings - Mounts to Hinged Rings - R080ET

Use this ring set to mount your 80mm Stellarvue finderscope to the top of a hinged mounting ring. The rings are 96 mm ID and the screws are stainless steel with nylon tips. The base is made to fit two popular ring widths. For the best fit your telescope mounting rings should be either 20 mm or 1” thick and have either a 1/4-20 or 6 mm threaded center hole. Most hinged rings have this. The ring set comes with both a 1/4-20 and 6 mm screw. Make sure to use the correct one for your ring set.


Our price: $50.00 (€43.50)
Quantity
Stellarvue 80 mm Finder Rings - Mounts to Most Finderscope Dovetail Shoes - R080DA

This ring set mounts to many dovetail shoes on the market including Stellarvue, Synta and others. The width of the foot at the bottom of the stalk measures about 1.21” (31 mm) maximum width and tapers to a width of about .82” (21 mm). The diagram below shows the dimensions of the stalk in millimeters:


Our price: $55.00 (€47.85)
Quantity
Stellarvue 80 mm Finder Rings - Mounts to Schmidt-Cassegrains - R080ST

Made to mount our 80 mm finderscopes to an SCT telescope. This has a bracket that attaches to the mirror cell on 8” and larger Celestron or Meade SCTs. A small dovetail shoe attaches to the bracket and the finder rings slide in and out of this shoe for easy, quick disconnect. The SCT shoe is larger in size than the shoe on the R80FA.


Our price: $60.00 (€52.20)
Quantity
Stellarvue 80 mm Finder Rings - Mounts to SV Clamshells, Flat or Curved Surface - R080AT

This ring set for 80mm finderscopes comes with a quick release dovetail shoe that mounts directly to the Stellarvue clamshells using two screws. It also mounts to the Stellarvue dual speed focuser using a single screw. It does not mount to the 2” Feather Touch focuser since the Feather Touch does not have any mounting holes. This is the one to choose for mounting the finderscope to a Dobsonian telescope either on a flat board or to a strut tube. It is our lightest finderscope ring system.

 


Our price: $50.00 (€43.50)
Quantity
Tellarvue 80 mm Finder Rings - Mounts to 2.5" - 3.5" Feather Touch Focusers - R080FA

Made to mount our 80 mm Stellarvue finder scopes to the Feather Touch 2.5”, 3” or 3.5" focusers. The shoe mounts to these specific focusers to any flat surface or to a tube that is 4” or greater in diameter. These WILL NOT mount to a 2" Feather Touch focuser. When installing the shoe on the Feather Touch focuser obtain 8-32 screws of the proper length. Please be aware if the screws are too long they will scratch the focuser drawtube. So take the shoe with you to make sure the screws are not too long.


Our price: $69.00 (€60.03)
Quantity
  •  per page