10mw and 20mw Green Laser Pointers at the Lowest Prices in the Country!!

10 mw only $80.00!

Camera Concepts imports and carefully inspects and selects these continuous output diode pumped green laser pointers. Each unit is personally tested for beam accuracy and intensity. They are designed for pointing to the desired targets or objects as far as 2 miles. A 532nm green laser is 30 times brighter and much more sensitive to human eyes than a 670nm red laser of the same power.

BRAND NEW!!

Arcturus Optics 20mw Green Laser Pointer

ONLY $119.95!

Powerful 20mw pointer will emit a beam strong enough to be seen in the most light polluted locations. A pointer of this brightness will be very effective when demonstrating to large groups where the angle of illumination is important.

Beginner's Eyepiece Kit: The Best Buy in the Astronomy Market!

The items in this kit are valued at over $700.00 if purchased separately!

Regular retail price of this kit is $399.00

*This special $139.00 offer is a LIMITED TIME OFFER!

Five Superior Grade Plössl Eyepieces -- 1.25": 4-element design with a 52° AFOV (32mm has 44°) -- Superb color, resolution, edge sharpness and clarity. All eyepieces are fully multi-coated for maximum contrast and resolution. Supplied are a 4mm, 6mm, 9mm, 15mm, and 32mm.

Barlow Lens -- 2x 1.25": Compliments the Plössl eyepieces in this kit and gives you a total of ten power combinations. The highest grade glass optics with fully multi-coated lenses are used so there is no degradation of image.

Six Colored Eyepiece (Planetary) Filters -- 1.25": Included are Kodak Wratten #12, #21, #25, #56, #58A, and #80A. Since you have all the eyepieces necessary to study the planets and moon in detail, these filters will greatly enhance your enjoyment of our solar system.

Moon Filter -- 1.25": A neutral density filter which allows you max

Keep Your Digits Warm and Toasty!

$18.00

High Quality Fingerless Gloves with a mitten overall flip up cover. Each Finger is exposed by simply pulling back the mitten cover. Even the thumb has its own pull back cover to allow you to manipulate those fine controls on your scope. The glove is composed of 40 grams of Thinsulate insulation.

Tripod Blinking Warning Lights

This is a great way to protect your tripod from being kicked after that gruesome setup.

These flashing lights will go for days on 2 AA batteries. They have a flash rate of about 120 per flashes per minute and the red LED is bright enough to bring attention to the legs on your tripod.

Each set consists of 3 flashers with Velcro to attach to your tripod legs.

$10.00 shipped to your door. Email us for foreign shipment price.

BRIGHT RED LIGHT PEN

Lights your way across the page

One quick click and your pen lights up, so you can write in the dark. Refillable twist actionballpoint with no cap to lose. A pleasure to write with.Batteries and extra refill included.

Only $10.00!

We Carry Those Hard to Find Caps and Plugs!

These caps and plugs are made from durable low density polyethelyne. Designed for easy installation and removal, they seat with a firm grip that prevents accidental removal.

1.25" size: $1.25 each

2.00" size: $1.50 each

SCREW BOLT STYLE EYEPIECE CASES

Are You Looking for a Unique Gift for an Astronomical Friend or Relative?

Check out our Magnificent Miniature Telescope Replicas handmade by Barry Crist. Click Here to check them out.

Dew-Not Heaters Made in the U.S.A.!

Proudly made in the USA, the Dew-Not Dew Remover is a thick film heater

manufactured for operation at 12 volts. Sixty-six percent of the surface area is

heat emitting - this means more even heat distribution and no localized hot spots

or burnouts often associated with resistance wire heaters. Protected by over 30

USA and international patents, and carrying more than 20 years of constant

improvements and enhancements, the Dew-Not Dew Remover is the ultimate in

reliability and efficiency.Dew-Not is available for all popular sized telescopes and custom sizes are

available upon request. Each heater comes with a standard six foot cord and phono-plug connector. So exactly what does this mean? Well for starters it means you use a lot less power. In simple terms the OTHER company design has a large amount of rubber involved as well as the fabric overlay. The result is that you must heat

the rubber and the fabric before any heat is transferred to your OTA or device.